How To Remove Rear Door Panel On 2004 Chevy Suburban

Remove the trim panel upper extension.

How to remove rear door panel on 2004 chevy suburban.

If you can reach inside the door to the final mechanism that everything pushes on push it yourself to see if it works 3. Raise or lower the rear of the seat cushion by raising or lowering the rear edge of the horizontal control. Also look on side of door for possible child saftey lock switch. Remove door lock solenoid and plug it into another door to see if it works 2.

Slide the screwdriver down until it contacts the snap and pry the snap out of the recess in the door. Place the common screwdriver at the top of the panel in between the door panel and the door. There are snaps on all three sides of the panel. Moving the whole horizontal control up or down.

Hello here is the instructions for removing the door panel. Remove the trim panel from the door carefully sliding the trim panel up to release the retainers from the door. Remove the courtesy light remove door panel screws. But there are 2 relays located in the i p fuse panel 1 is for lock 1 is for unlock.

My 2003 chevy suburban door locks for the 2 rear doors and the tail gate door do not work properly. Pull drivers rear door panel off 1. Hey everyone today s video is a quick lesson on how to remove the door panels on a 2000 2006 nbs chevy suburban tahoe silverado also gmc yukon xl cadilla. Remove the trim panel screws.

2004 suburban rear doors and tailgate wont unlock with buttons. Remove the door panel using the common screwdriver. Remove the door handle bezel. Do the same to all the snaps.

Remove the window handle.