Wire brush the metal thoroughly to get rid of rust and to give the tape a clean surface for bonding photo 1.
Gutter nails pulling out.
Do not let the ferrule slip away or fall off from the roof.
Prepare the gutter by scraping out as much old tar or caulk as possible.
Gutter nails or spikes used to hold rain gutters in place can work themselves loose with seasonal movement.
Place the claw of your hammer on the end of the spike and pull it straight out from the gutter.
Make sure that you place the gutter nail in a safe waste bin and don t leave it lying around on the roof.
You ll need drop outlets to connect the gutters to the downspouts.
Don t waste your time or gutters trying to pry out the old aluminum nails.
Other pieces include elbows gutter extensions and gutter flashing.
Wire brush the metal thoroughly to get rid of rust and to give the tape a clean surface for bonding photo 1.
If the gutter is badly rusted or has been heavily coated with tar that you can t scrape out spray on a special adhesive primer before applying the tape protecto tek is one brand but you may need to special order it.
Get a gutter screw.
Gutter end caps close off the ends of gutters keeping debris and water from flowing out at this point.
Measure the gutter and cut the block to fit snugly between the fascia and the outer lip of the gutter filling the void with solid wood.
Slide it into the hole on the side of the gutter and into the ferrule.
If the gutter is badly rusted or has been heavily coated with tar that you can t scrape out spray on a special adhesive primer before applying the tape protecto tek is one brand but you may need to special order it.
If the nail is loose simply pull it out from the side of the gutter.
Use a pry bar to remove the gutter nail completely.
Look for the end of the gutter spike sticking out from the front side of your gutter.
Then simply place the block in the gutter and use your hammer or pry bar against it to pull out the nail and remove the ferrule.
Set the nail aside.
Just cut the aluminum nails with bolt cutters and then slide the gutters off.
Here s a quick fix for that problem demonstrate.
I have a 24 bolt cutter which cut those nails like butter.
Work with one nail at a time.
Take your hammer and slide the claw piece under the first of the gutter nails.
Gutter hangers and gutter brackets allow gutters to attach to a house s eaves offering support and strength to the front edge.
If it is still secured firmly use a claw hammer to pull it off.
After the gutter is clear then you can use the pry bar to pull out the stubs.
Rock the hammer back and forth to help work the spike out from the fascia board if it doesn t pull out easily.
